LG LSP-W1000N User Manual download pdf (Page 14)

System operation

After the power is inputted for the first time to turn on

the unit or set the unit as factory resetting, you will

set the initial Administrator password and wireless

setup manually.

1. The camera mode select switch is correctly set

to Wired position. Connects the camera(s) to the

main unit using the Ethernet cable.

2. Connects the main unit to the monitor or display

unit and turn them all on.

3. When the booting is completed the Password

Setup window will be displayed. You can make

the user password for this unit.

4. Input a new password more than 4-digit numbers

and press ENTER. You can enter the password

from minimum 4-digit numbers to 8-digit numbers.

Enter it again and press ENTER to verify. If you

make a mistake before pressing ENTER, press b.

5. Wireless Setup menu is displayed.

6. Use V v b B to select the desired setting as

shown below.

- SSID: You can change the SSID. Set the iden-

tifier for the wireless network local in use.

- Band: Select the band (2.4GHz (G) or 2.4GHz

(B+G)).

- Channel: Select the channel.

- WEP Key: You can set the WEP key to protect

a wireless signal between this Netstation and

connected camera(s). The WEP key is ran-

domly created.

7. Press ENTER while [Apply] option is selected.

Update window is displayed and update will

start. After update is completed, the Camera

Registration menu is displayed.

To register the camera(s), see page 17.

8. After all settings are completed, press RETURN

and select [Yes] then press ENTER to confirm

your setting.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

No comments

LG LSP-W1000N User Manual Page 14