Using Multi-Room 15
Using Multi-Room
3
,
Note for Multi-Room Setup
y
You can make all wireless/wired connection according to the location of the router. But we recommend that
you connect the rst speaker or bridge to the router using LAN cable and connect additional speakers for
network stability.
y
When the “Firmware update” pop-up appears on Music Flow Player App, touch to start updating.
y
If you connected a speaker with a LAN cable and installed additional speakers: If the speaker with frequent
sound breaking is not close enough with the cable connected speaker, install a Bridge or another speaker in
the middle location between the speaker connected with LAN cable and the speaker with sound breaking,
and try again.
y
Even if you connected speakers with MUSIC ow mesh network, music sound breaks by ambient signal
interference causing Wi-Fi network defect. In this case, you can try to change Mesh network channel of
MUSIC ow system at the [Settings
à
Advanced settings
à
Mesh Network Channel]
y
When making connection, “Mesh network composition” may appear and it takes about 30 seconds. This
message appears once in rst installation but may appear again when you change network environment.
Using the Bridge
1. Use as a root device (wired to the home router)
When your home router is located too far from any speaker location that is to be connected via wired mode:
a
According to “Simple Setup Guide (Wired Connection)”, connect the Bridge to your home router with LAN
cable.
b
According to “Simple Setup Guide (Add Speakers)“, add MUSIC flow products to your home network.
a
b
Bridge
2. Use as a wireless extender
When you want to expand MUSIC ow mesh network coverage:
Preparation: Initial MUSIC ow product is connected to your home router with LAN cable.
a
According to “Simple Setup Guide (Add Speakers)“, add the Bridge to your home network.
b
According to “Simple Setup Guide (Add Speakers)“, add MUSIC flow products to your home network.
a
b
Bridge
Comments to this Manuals