LG LSW140B User Manual download pdf (Page 5)

ENGLISH

Installation method

How to attach to masonry walls

- Check the material of the wall and the thickness of the finishing.

- When installing the product on wall material not designated, install the product so that each fixated location

can withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.

- Use the Ø8 mm drill bit for concrete and hammer (Impact) drill.

Please follow the below direction.

d e

a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm.

b. Clean the drilled hole.

c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)

d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face

upward.

e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.

Wall mount screw

Anchor

- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry

brick and hallow block that do not crack.

How to install the wall mount

Wall mount

screw

→

If the screw cannot be assembled in the designated location

inevitably, it can be assembled by rearranging to the closest

location. But, do not change 2 or more locations from the

designated spot.

→

Assemble the wall mount screw on 1 left and 1 right location

on the top part and 1 left and 1 right location on the bottom

part.

→

At this time, use a "+" driver (Manual or motorized) or 8 mm

wrench to tighten the screw so that the wall, wall bracket and

screw are completely pressed against one another.

1 2 3 4 5 6 7 8

No comments

LG LSW140B User Manual Page 5