LG LT303PI-B User Manual download pdf (Page 11)

Installation

Dipswitch Setting

The camera has one 4 bit switches that determine the

protocol and baud rate of the data communication.

Settings are loaded when the camera boots up. Be

sure to turn the camera off, change the dipswitch set-

tings, then power back up to load the changes.

1. Turn off the camera.

2. Remove the dome cover from the housing.

3. Set the dipswitches inside the housing as per the

table below.

4. Power up the camera to load the changes.

SW101

Switch position (SW101) Protocol

(ON ON ON ON) Reserved 1

(ON OFF ON ON) LG Multix

(OFF ON ON ON) Pelco D

(OFF OFF ON ON) Pelco P

(ON ON OFF ON) Reserved 2

(OFF ON OFF ON) Reserved 3

(ON OFF OFF ON) Reserved 4

(OFF OFF OFF ON) Reserved 5

(ON ON ON OFF) Reserved 6

(OFF ON ON OFF) Reserved 7

(ON OFF ON OFF) Reserved 8

(OFF OFF ON OFF) Reserved 9

(ON ON OFF OFF) Reserved 10

(OFF ON OFF OFF) Reserved 11

(ON OFF OFF OFF) Reserved 12

(OFF OFF OFF OFF) Reserved 13

Note:

If you are not using the controller with LG Multix proto-

col, there may be some limitation of function control.

SW104

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

LG LT303PI-B User Manual Page 11