LG DLGX7601KE Owner's Manual download pdf (Page 54)

54

TROUBLESHOOTING

Problem Possible Cause Solutions

Clothes take too long to

dry

Exhaust ducts are blocked, dirty,

or duct run is too long.

Confirm that the exhaust duct is properly

configured and free of debris, lint, and

obstructions. Make sure that outside wall

dampers can open properly and are not

blocked, jammed, or damaged.

Load is not properly sorted.

Separate heavy items from lightweight

items. Larger and heavier items take

longer to dry. Light items in a load with

heavy items can fool the sensor because

the light items dry faster.

Clothes take too long to

dry

Large load of heavy fabrics.

Heavy fabrics take longer to dry because

they tend to retain more moisture. To help

reduce and maintain more consistent

drying times for large and heavy fabrics,

separate these items into smaller loads of

a consistent size.

Dryer controls are not set

properly.

Use the appropriate control settings for

the type of load you are drying. Some

loads may require an adjustment of the

dry level setting for proper drying.

Lint filter needs to be cleaned.

Remove the lint from the filter before

every load. With the lint removed, hold

the filter up to a light to see if it is dirty or

clogged. With some loads that produce

high amounts of lint, such as new bath

towels, it may be necessary to pause the

cycle and clean the filter during the cycle.

House fuse is blown, circuit

breaker has tripped, or power

outage has occurred.

Reset circuit breaker or replace fuse. Do

not increase fuse capacity. If the problem

is a circuit overload, have it corrected by

a qualified electrician.

NOTE

Due to the design of electric dryers,

it is possible for a circuit problem to

allow an electric dryer to run without

heat.

Dryer is overloaded.

Divide extra large loads into smaller

loads for better drying performance and

efficiency.

Dryer is underloaded.

If you are drying a very small load, add a

few extra items to ensure proper tumbling

action. If the load is very small and you

are using SENSOR DRY cycles, the

electronic control cannot properly sense

the dryness of the load and may shut off

too soon. Use TIME DRY or add some

extra wet clothes to the load.

MFL67731070_en_170711.indd 54 2017-07-11 오후 4:05:16

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 131 132

Comments to this Manuals

No comments