LG WF-T556 User Manual download pdf (Page 6)

nstallation

Introduction

●

Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any

water that may leak out should the machine malfunction.

It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a drain hole

(or slope) that will prevent any possibility of water damage to floor coverings or property.

✽

“ Washing machine is to be connected to the water mains using new hose-sets and that old hose-sets should not be

reused ”

❏ NOTE

●

Never lay down the drain hose, as water will be discharged.

●

Be sure the drain hose is properly routed so it will not kink or lift from the sink.

●

To prevent syphoning, the drain hose should not extend more than 50 mm

from the end of the hose guide.

●

The discharge height should be approximately 0.9~1.2m from the floor.

●

Connect the drain hose to the

outlet of the drain pump located

at the rear of the washing

machine.

●

Attach the clip to the drain hose. And

then push it toward the body of the

washing machine as

indicated by the arrow.

●

Place the hose guide over the

laundry tub or the stand pipe.

●

Do not use an extension hose.

●

Check that sealing washers are firmly seated.

●

Attach the curved end of the hose to the inlet valve of the washing

machine; Tighten the coupling nuts securely by hand. (Fig. 1)

●

Attach the straight end of the hose to the tap.

Tighten the coupling nuts securely by hand. (Fig. 2)

●

Another hose can be attached to hot inlet valve and tap.

●

Turn on the taps and check for leaks. Tighten the coupling nuts firmly

if there is any leakage. If water pressure is strong, close the water tap

completely then open it slightly.

●

Do not install the washer where it is directly exposed to sunlight, wind, rain etc.

●

Plug the power cord of this washer into a properly installed standard power point that is switched & earthed.

●

Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL

FLOW of any water that may leak out should the machine malfunction.

It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with

a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.

●

Permissible water temperature : Max 70°C(160°F)

●

Permissible water pressure : Max 80psi (550kpa, 8kg/cm

), Min 4psi (30kpa, 0.3kg/cm

)

●

If water temperature & pressure is greater than above, it may cause damage to the machine. If you

have uncontrolled water temperature & pressure you should fit a temperature & pressure relief valve

to ensure that water temperature & water pressure remains within the safe limits. Consult a plumber

or electrician if you are unable to adjust water temperature and pressure.

●

Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.

Connect the drain hose

Flooding drainage

Connect the inlet hose

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Comments to this Manuals

No comments

LG WF-T556 User Manual Page 6

Comments to this Manuals

Related products and manuals for Washing machines LG WF-T556