INSTALLATION INSTRUCTION
15
ENGLISH
This function is to adjust FAN Airflow rate ac-
cording to ceiling height (For ceiling type prod-
uct)
1 Press button and button Simulta-
neouslly for more than 3 seconds.
2 Setup function code ’05’ pressing by
button.
3 Set Thermistor value by pressing button by
pressing temperature button.
(01: Remote Controller, 02: Indoor, 03:
2TH)
4 Press button to save.
5 Press button and button Simulta-
neouslly for more than 3 seconds After the
setting has been completed.
This function is applied to only duct type. Set-
ting this in cases will cause malfunction.
1 Press button and button Simulta-
neouslly for more than 3 seconds.
2 Setup function code ’06’ pressing by
button.
3 Set Thermistor value by pressing button by
pressing temperature button.
(01: V-H, 02: F-H, 03: V-L, 04:F-L)
4 Press button to save.
5 Press button and button Simulta-
neouslly for more than 3 seconds After the
setting has been completed.
NOTE
!
• Ceiling height setting is available only for
some products.
• Ceiling height of “Very high” function
may not exist depending on the indoor
units.
• Refer to the product manual for more
details.
Pressure
selection
Function
Zone
state
ESP
standard
value
01 V-H Variable High
02 F-H Fixed High
03 V-L Variable Low
04 F-L Fixed Low
Static Pressure Setting
Ceiling Height Selection
Comments to this Manuals