LG LA100SC User Manual download pdf (Page 8)

Remote Control Operations

Operating

Instructions

The remote control and control panel will look like one of the following pictures.

POWER

Operation starts when this button is pressed and stops when you press the button again.

OPERATION MODE SELECTOR

Select cooling mode to cool the room.

Select fan mode for basic ventilating fan operation.

Dry mode is used to remove humidity from the room without additional cooling .Once the set temperatureies

reached , the compressor and circulation fan turns off , Fan speed is pre-set and cannot be adjusted.

ON/OFF TIMER

The timer can be set to start and stop the unit in hourly increments (up to 12 hours).

FAN SPEED SELECTOR

Press this button repeatedly to adjust the fan speed: High[F3]→Low[F1]→Med[F2]

For increased power while cooling select a higher fan speed.

TEMPERATURE CONTROL

The thermostat monitors room temperature to maintain the desired temperature.

The thermostat can be set between 16 °C~30 °C (61 °F~86 °F).

The unit takes an average of 30 minutes to adjust the room temperature by 1 °C (1.8 °F).

AUTO SWING BUTTON (available in some models)

Allows the unit to automatically swing its louvers left and right during operation. If the option is

de-selected, the louvers will stop in their last position and orient the airflow in the corresponding direction.

ENERGY SAVER

The fan stops when the compressor stops cooling.

When using the remote control, hold its transmitter facing the sensor.

Approximately every 3 munutes the fan will turn on and check the room air to determine if cooling is needed.

REMOTE SENSOR

°C

Power

Temp

Fan Speed

Timer Mode

Energy

Saver

Auto

Swing

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

LG LA100SC User Manual Page 8