LG ARNU15GQAA2.ENWALEU User Manual download pdf (Page 17)

Installation Manual 17

Terminal block of indoor unit

Terminal block of outdoor unit

1(L) 2(N) 3(A) 4(B)

Indoor power input

220V 60Hz

IDU IDU

Outdoor unit

Indoor unit

Central controller

SODU SODU

DRY1

DRY2

GND

INTERNET

12V

• Connect the wires to the terminals on the control board individually according to the outdoor unit connection.

• Ensure that the color of the wires of outdoor unit and the terminal No. are the same as those of indoor unit respectively.

Wiring Connection

Make sure that the screws of the terminal are free from looseness.

The Power cord connected to the unit should be selected according to the following

specifications.

After the confirmation of the above conditions, prepare the wiring as follows:

1) Never fail to have separate power specially for the air conditioner. As for the method of wiring, follow the cir-

cuit diagram pasted on the inside of control box cover.

2) Provide a circuit breaker switch between power source and the unit.

3) The screw which fasten the wiring in the casing of electrical fittings are liable to come loose from vibrations to

which the unit is subjected during the course of transportation. Check them and make sure that they are all

tightly fastened. (If they are loose, it could give rise to burn-out of the wires.)

4) Confirm the Specification of power source

5) Confirm that electrical capacity is sufficient.

6) Be sure that the starting voltage is maintained at more than 90 percent of the rated voltage marked on the

name plate.

7) Confirm that the cable thickness is as specified in the power sources specification.

(Particularly note the relation between cable length and thickness.)

8) Do not install the leakage breaker in a place which is wet or moist.

Water or moist may cause short circuit.

9) The following troubles would be caused by voltage drop-down.

• Vibration of a magnetic switch, damage on the contact point there of, fuse breaking, disturbance to the normal function

of a overload protection device.

• Proper starting power is not given to the compressor.

Installation

ENGLISH

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Comments to this Manuals

No comments

LG ARNU15GQAA2.ENWALEU User Manual Page 17

Comments to this Manuals

Related products and manuals for Unknown LG ARNU15GQAA2.ENWALEU