LG GF-D725BML User Manual download pdf (Page 10)

10

INSTALLATION

Choosing the Proper Location

•

The fridge should always be plugged

into its own individual properly grounded

electrical outlet rated for 240 Volts, 50 Hz,

AC only, and fused at 15 or 20 amperes.

This provides the best performance and

also prevents overloading house wiring

circuits which could cause a fire hazard from

overheated wires. It is recommended that a

separate circuit serving only this appliance

be provided.

•

After installing the appliance, connect the

power plug into a socket outlet. Before

moving and discarding the appliance,

disconnect the plug from the socket outlet.

Unpacking Your Fridge

WARNING

•

Use two or more people to move and install

the fridge. Failure to do so can result in back

or other injury.

•

Your fridge is heavy. When moving the fridge

for cleaning or service, be sure to protect

the floor. Always pull the fridge straight

out when moving it. Do not wiggle or walk

the fridge when trying to move it, as floor

damage could occur. Wind the leveling feet

up first so that the unit is on its rollers.

•

Keep flammable materials and vapors, such

as gasoline, away from the fridge. Failure to

do so can result in fire, explosion, or death.

Remove tape and any temporary labels from your

fridge before using. Do not remove any warning-

type labels, the model and serial number label, or

the Tech Sheet that is located under the front of

the fridge.

To remove any remaining tape or glue, rub the

area briskly with your thumb. Tape or glue residue

can also be easily removed by rubbing a small

amount of liquid dish soap over the adhesive with

your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol,

flammable fluids, or abrasive cleaners to remove

tape or glue. These products can damage the

surface of your fridge.

Fridge shelves are installed in the shipping

position. Please reinstall shelves according to

your individual storage needs.

Flooring

To avoid noise and vibration, the unit must be

leveled and installed on a solidly constructed

floor. If required, adjust the leveling legs to

compensate for unevenness of the floor. The

front should be slightly higher than the rear to

aid in door closing. Leveling legs can be turned

easily by tipping the cabinet slightly. Turn the

leveling legs to the left to raise the unit or to

the right to lower it. Poorly constructed timber

flooring can cause a limit in door adjustment

and the cabinet to become out of shape. (See

Leveling and door AlIgnment.)

NOTE

Installing on carpeting, soft tile surfaces,

a platform or weakly supported structure

is not recommended.

WARNING

To reduce the risk of electric shock, do not

install the fridge in a wet or damp area.

do not install in any outdoor or sheltered

outdoor location or direct sunlight.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments