LG GF-SD730SL User Manual download pdf (Page 23)

HOW TO USE

Before use

Clean the fridge.

Clean your fridge thoroughly and wipe off all dust that accumulated during shipping.

NOTE

Remove adhesive residue by wiping it off with your thumb or dish detergent.

CAUTION

Do not scratch the fridge with a sharp object or use a detergent that

contains alcohol, a flammable liquid or an abrasive when removing any tape

or adhesive from the fridge,.

Do not peel off the model or serial number label or the technical information

on the rear surface of the fridge.

Connect the power supply.

Check if the power supply is connected before use.

Read the “Turning On The Power” section. (Your plug type might be different from

the picture.)

CAUTION

Running the automatic icemaker before connecting it to the water

supply may cause the fridge to malfunction.

Turn off the icemaker if the fridge is not yet connected to the

water supply.

Turn off the automatic icemaker and then plug the power plug of the fridge into the

grounded electric outlet.

* This is applicable only to certain models.

CAUTION

Putting food in the fridge before it has cooled could cause the food to

spoil, or a bad odor could linger inside the fridge.

Wait for the fridge to cool.

Allow your fridge to run for at least three to four hours before putting food in it.

Check the flow of cold air in the freezer compartment to ensure proper cooling.

The fridge makes a loud noise after initial operation.

This is normal. The general noise levels will decrease as the temperature lowers.

Open fridge doors and freezer drawers to ventilate the interior.

The inside of the fridge may smell like plastic at first. Remove any adhesive tape

from inside the fridge and open the fridge doors and the freezer drawers for one to

two hours before turning on.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

No comments

LG GF-SD730SL User Manual Page 23