LG ELITE CVF User Manual

Report No. 317-F-09-5INSTALLATION AND OPERATION MANUALDo not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any

Figure 10Figure 11Figure 1216.0 SPARK GAPThe gap between the spark electrode and the pilot should be 1/8” to 3/16” to produce a good spark. There sho

1119.0 SERVICING (continued)3. Remove the glass door assembly (4 screws) and clean carefully. Detach the burner front cover plate by removal of

23.0 TESTING FOR FIREBOX LEAKAGEAppliances that are several years old or have been extensively dismantled should be checked for soundness. It is impor

13FOR YOUR SAFETY READ BEFORE LIGHTINGWARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAYRESULT CAUSING PROPERTY DAMAGE,

1426.0 TROUBLESHOOTING GUIDEPROBLEM CORRECTIVE ACTIONIgniter sparks but pilot does not light • No gas to Pilot, check the gas line connections.• Ai

1527.0 REPLACEMENT PARTS - Elite CVF - NG and Elite CVF - LPItem # Cat. No. Description1 H7009 Glass Door Assembly2 H7038 Gas Valve3 H6060 Catalyst4 H

16Figure 16 - Visual check for correct pilot flame. WARNING Failure to position the parts in accordance with these diagrams or failure to use

1729.0 SPECIFICATIONS6-1/4”23-7/8”27-3/16”9-3/16”20-1/4”Back ViewTop ViewFront ViewProduct Reference InformationCat. No. Model Ship. Wt. Ship. VolumeH

Printed in U.S.A. © 2008 Lennox Hearth ProductsP/N 850,056M REV. NC 07/2008Lennox Hearth Products reserves the right to make changes at any time, w

2• Children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns or clothing ignition.• Young

32.0 GENERAL INFORMATIONThis appliance is a high efficiency, unvented, flame effect gas heater. It provides radiant and convected warmth both efficientl

6.0 BURN-IN PERIOD4On initial light up of a new appliance, the ‘newness’ will burn off within the first few hours of operation. During this period some

58.0 COMBUSTION AND VENTILATION AIRThis heater shall not be installed in a confined space or unusually tight construction unless provisions are provide

9.0 SITE REQUIREMENTSThis appliance is designed to be wall-hung. Do not recess any part of the appliance into the wall.This appliance may be installed

Figure 1 - Gas Supply Entry Points10.0 PREPARING THE APPLIANCEIMPORTANT NOTE: All gas piping must be done by a licensed plumber or gas fitter and must

Figure 311.0 MOUNTING THE APPLIANCE - continuedBefore tightening the wall-mounting screws fully, at this stage it is recommended to check the

Retaining clipBurner(Manifold) PressureRegulatorPressureSettingTurn on gas supply and test for gas leaks using a gas leak test solution (also referred