LG F1480RD26 User Manual

OWNER’S MANUALWASHING MACHINE F1480RD2(1~9)P/No. : MFL62644962www.lg.comBefore beginning installation, read these instructions carefully. This will si

10• Level floor :Allowable slope under entire washer is 1˚• Power outlet :Must be within 1.5 meters of either side of location of washer.Do not overlo

11InstallationCAUTIONCAUTION concerning the Power cord• Most appliances recommend they be placed upon a dedicated circuit; that is, a singleoutlet cir

121. Unscrew the adapter ring plate and the 4adapter retaining screws.2. Push the adapter onto the end of the tapso that the rubber seal forms a water

131. Unscrew the adapter ring plate and the 4 adapter retaining screws.2. Remove the guide plate if the tap is too large to fit the adapter.3. Push th

14 Installation of drain hose• The drain hose should not be placedhigher than 100 cm above the floor.Water in the washer does not drain ordrains slow

15•Diagonal CheckWhen pushing down the edges of thewashing machine top plate diagonally, the machine should not move up and downat all (Please, check

16❿Concrete floors❿Wooden floors (Suspended floors)• The installation surface must be clean, dry and level.• Install washer on a flat hard floor.❿T

17How to use washer Operating washing machine2. Open the door and load laundry.1. Sort Laundry.(Refer to 18 page)3. Press the Power button.4. Select

18 Care before washing3. Caring before loadingCombine large and small items in a load. Load large items first.Large items should not be more than hal

19 Washing program table• Recommended courses according to the laundry type.ProgramDescriptionFabric typeProperTemp.MaximumLoadCottonProvides better

Contents2Contents...2Product Features...3Important safety instructionsImportant safety instruction

20The wool wash cycle of this machine has been approved by Woolmark forthe washing of machine washable Woolmark products provided that theproducts are

21 Extra options* : This option is automatically included in the cycle and can not be deleted.** : This option is automatically included in the cycle

22 Control panelStart/PausebuttonOptionbuttonsBeepOn/OffPowerbuttonDry dialTubCleanTemp.buttonSpinbuttonChild LockAdditional programbuttonsLED displa

231. Press the Power button.2. Select a cycle.3. Press the Time Delay button and set timerequired.4. Press the Start/Pause button.You can set a time d

24• Spin Speed level can be selected bypressing 'Spin' button repeatedly.1. Press the Power button.2. Press the Spin button to select RPM.3.

25The Beep on/off function can be set only during the washing cycle.1. Press the Power button.2. Press the Start/Pause button.3. Press and hold the Op

26Tub Clean is a special cycle to clean the inside of the washing machine. A higher water level is used in this cycle at higher spin speed. Perform th

27• Use your Automatic Cycles to dry mostloads. Electronic sensors measures thetemperature of the exhaust to increase ordecrease drying temperatures f

28- Do not tumble dry woolen articles. Pull them totheir original shape and dry them flat.Woolen Articles- Some woven and loopknit materials mayshrink

29• Main wash only ➔• Pre Wash + Main Wash ➔• Do not exceed the maximum fill line. Overfilling can cause early dispensing of thefabric softener which

Product Features3Inverter Direct Drive systemThe advanced Brushless DC motor directly drives the drum without belt and pulley.More economical with Int

30Adding detergent• Detergent should be used according to the instruction of the detergent manufacture.• If too much detergent is used, too many suds

31 The water inlet filter•" " icon will be displayed on the control panel when water does not enter thedetergent drawer.•If water

32•Allow the water to cool down before cleaning the drain pump, carrying out emergencyemptying or opening the door in an emergency.•The drain filter c

33 Dispenser drawer• After a while, detergents and fabric softeners leave a deposit in the drawer.• It should be cleaned from time to time with a jet

34• Proper care of your washer can extend its life.• The outside of the machine can be cleaned with warm water and a neutral non abrasive householddet

35• This washing machine is equipped with automatic safety functions which detect anddiagnose faults at an early stage and react appropriately.When th

36Washer does notstartWasher will notspinDoor does notopenWash cycle timedelayedFabric softeneroverflowSoftenersdispensed too earlyDry problem• Electr

37Symptom Possible Cause Solution• Water supply is not adequate in area.• Water supply taps are not completelyopen.• Water inlet hose(s) are kinked.•

38• Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning except

39What Is Not Covered:• Service trips to your home to teach you how to use the product. • If the product is connected to any voltage other than that s

4Important safety instructionsFor your safety, the information in this manual must be followed to minimize the risk of fire orexplosion, electric shoc

5Important safety instructionsTo reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basicprecautions, includi

6Important safety instructions Basic safety precautions Save these instructionsTo reduce the risk of fire, electric shock, or injury to persons when

7Important safety instructionsTo minimize the risk of fire within the inner bowl, the following should be observed:• Items that have been spotted orso

8 Name : Front loading washing machine Power supply : 220 - 240 V~, 50 Hz Size : 600 mm(W) ✕ 640 mm(D) ✕ 850 mm(H) Weight : 72 kg Max.Watt :

9Installation Removing packing1. Remove the cardboard box andstyrofoam packing.2. Lift the washing machine and removethe base packing.3. Remove the t