LG F1443KDS27 User Manual download pdf (Page 10)

1. Unscrew the adapter ring plate and

the 4 adapter retaining screws.

2. Remove the guide plate if the tap is

too large to fit the adapter.

3. Push the adapter onto the end of

the tap so that the rubber seal forms

a watertight connection.

Tighten the adapter ring plate and

the 4 screws.

4. Pull the connector latch plate down,

push the inlet hose onto the adapter,

and release the connector latch plate.

Make sure the adapter locks into place.

nstallation

After completing connection, if water leaks from the hose, repeat the same steps.

Use the most conventional type of faucet for water supply. In case the faucet is square

or too big, remove the spacing ring before inserting the faucet into the adaptor.

Please use the horizontal tap

Horizontal tap Extension tap Square tap

Ring plate

Guide plate

Latch plate

Type-C : Connecting one touch type hose to tap without thread

Step3: Connect hose to washer

• Make sure that there are no kinks in the

hose and that they are not crushed.

When your washer has two valves.

• The Inlet hose which has red connector is

for the hot water tap.

• If the washer has two valves, the energy is

saved by using hot valve.

After connecting inlet hose to

water tap, turn on the water tap

to flush out foreign substances

(dirt, sand or sawdust) in the

water lines. Let water drain into a

bucket, and check the water

temperature.

1 ... 9 10 11 ... 36

No comments

LG F1443KDS27 User Manual Page 10