LG HN0916.NK1 User Manual download pdf (Page 10)

10 Air-to-Water Heat Pump

Selecting Target Temperature

❊ Note

: Decrease 1°C or 2°F per one time pressing

: Increase 1°C or 2°F per one time pressing

• We can change the temperature range of each mode on installation setting mode. Please refer

Function Code 11 to 15.

• Room Temperature setting is available when Remote Room Air Sensor (sold separately) is

installed. Please refer Function Code 03.

• Sanitary Water Tank temperature setting is available when Sanitary Water Tank is installed.

Owner's instruction

Mode Change

Turn on the product and select operation mode.

Operation Mode

• Cooling Operation - The product yields cool water to use in under floor cooling or FCU cooling.

• Heating Operation - The product yields hot water to use in under floor heating or FCU heating.

• Weather dependent Heating Operation - In this mode, heating setpoint is automatically determined

by pre-defined temperature profile.

Press Power Button to turn on the product.

Press OPER MODE Button to select each operation mode.

Cooling operation Heating operation Weather dependent

operation

Press SET TEMP Button to select each operation mode.

Adjust desired temperature by pressing Change Temperature buttons on each mode.

To raise the Temperature

To lower the Temperature

Room temperature Leaving Water

temperature

Sanitary Water Tank

temperature

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

No comments

LG HN0916.NK1 User Manual Page 10