LG RC8066BS2Z User Manual download pdf (Page 10)

Installation Instructions

nstallation Instructions

Connecting the water supply hose

Step 1 : Check rubber seal in the inlet hose.

Two rubber seals are supplied with the water inlet

hoses.

They are used for preventing water leaks.

Make sure the connection to the tap is sufficiently

tight.

The dryer must be connected to the cold water tap using the new water supply hose. Do not use old

hoses.

Periodically inspect and replace hoses if bulges, kinks, cuts, wear or leaks are found.

Note

• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm

• Do not strip or cross-thread when connecting inlet hose to the valve.

• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.

• Periodically check the condition of the hose and replace the hose if necessary.

Hose

connector

Y connector

Short

hose

Long

hose

Rubber

seal

Note

•

After connecting the inlet hose to water tap, turn

on the water tap to flush out foreign substances

(dirt, sand or sawdust) in the water lines.

Let water drain into a bucket, and check the

water temperature.

Step 2 : Check the installation environment.

A type

-. When using both washer and dryer with one

water tap.

Assemble Y connector and short hose.

Connect the female part of the short hose to the

water tap.

Connect the male part of Y connector to the

female part of the long hose.

Connect another male part of Y connector to the

female part of the inlet hose of washer.

B type

-. When using only the dryer from one tap.

Connect the female part of the long hose to the

water tap.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

LG RC8066BS2Z User Manual Page 10

Comments to this Manuals

Related products and manuals for Tumble dryers LG RC8066BS2Z