LG VR6340LV User Manual download pdf (Page 27)

CLEANING THE DUST BIN

1. Open the dust bin cover by pressing the PUSH

button on the Robot Cleaner.

2. Grab the handle of the dust bin and pull it

upward.

3. Pull the hook on the left of Filter Cover on the

rear of Dust Bin to separate the ﬁ lter and the

sponge.

※

Note that separating the ﬁ lter may result in

dust dropping.

※

Refer to p.26 when cleaning the Dust Bin Filter.

4. Lift the cover upward while pressing the

separation button on the dust bin.

5. Empty the dust bin and clean it with a cleaning

brush or under running water.

6. After cleaning with water, completely dry the

dust bin in a well-ventilated area out of the direct

sunlight.

7. When reassembling or ﬁ tting the cleaned Dust

Bin, close the cover and put in the Sponge and

HEPA Filter.

※

Refer to p.26 for detailed assembly guides.

8. Put the dust bin into the Robot Cleaner and close

the dust bin cover.

If the dust bin is full, suction power can be reduced. Clean the dust bin before and after each cleaning

session. Clean the dust bin using the following sequence:

• Operating the unit without Filters fitted to the dust bin can cause a motor malfunction not

covered by warranty.

• After cleaning the Dust Bin, make sure to assemble the filter and fit it to the Dust Bin.

If you initiate cleaning, with no filters fitted to the dust bin or Filter Cover not assembled,

a voice message will be announced which says "Please check that the dust bin and filter are

properly installed."

• Always ensure that the dust bin cover is refitted correctly after

cleaning the dust bin so that it closes easily and accurately.

Tip

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

LG VR6340LV User Manual Page 27