LG LFC25770SW User Manual download pdf (Page 31)

INSTALLATION INSTRUCTIONS

(CONTINUED)

4. FASTEN THE SHUTOFF VALVE

Fasten the shutoff valve to the cold water pipe with

the pipe clamp.

NOTE: Commonwealth of Massachusetts Plumbing

Codes 248CMR shall be adhered to. Saddle valves

are illegal and use is not permitted in Massachusetts.

Consult with your licensed plumber.

5. TIGHTEN THE PIPE CLAMP

Tighten the clamp screws until the sealing washer

begins to swell.

NOTE: Do not overtighten or you may crush the tubing.

6. ROUTE THE TUBING

Route the tubing between the cold water line and the

refrigerator.

Route the tubing through a hole drilled in the wall or

floor (behind the refrigerator or adjacent base cabinet)

as close to the wall as possible.

NOTE: Be sure there is sufficient extra tubing (about 8

feet coiled into 3 turns of about 10" diameter) to allow

the refrigerator to move out from the wall after

installation.

7. CONNECT THE TUBING TO THE VALVE

Place the compression nut and ferrule (sleeve)

for copper tubing onto the end of the tubing and

connect it to the shutoff valve. Make sure the tubing is

fully inserted into the valve. Tighten the compression

nut securely.

NOTE: Commonwealth of Massachusetts Plumbing

Codes 248CMR shall be adhered to. Saddle valves

are illegal and use is not permitted in Massachusetts.

Consult with your licensed plumber.

8. FLUSH OUT THE TUBING

Turn the main water supply on

and flush out the tubing until the

water is clear.

Shut the water off at the water

valve after about one quart of

water has been flushed through

the tubing.

CONNECTING THE WATER LINE

Pipe Clamp

Vertical Cold

Water Pipe

Saddle-Type

Shutoff Valve

Saddle-Type

Shutoff Valve

Ferrule (sleeve)

Compression Nut

Packing Nut

Outlet Valve

Pipe Clamp

Inlet End

Washer

Clamp Screw

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

LG LFC25770SW User Manual Page 31

Comments to this Manuals

Related products and manuals for Fridges LG LFC25770SW