Audio
5.1 Speaker Setup
Make the following settings for the built-in 5.1
channel surround decoder.
1. Select [5.1 Speaker Setup] on the [Audio]
menu.
2. Press
ENTER.
The [5.1 SPEAKER] appears.
3. Use
I i
to select the desired speaker.
4. Adjust options using
U u I i
buttons.
5. Returns to the previous menu by pressing
O
RETURN.
[Speaker selection]
Select a speaker that you want to adjust.
NOTE
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
[Size]
Since the speaker settings are xed, you
cannot change the settings.
[Volume]
Press
I i
to adjust the output level of the
selected speaker.
Front L/R : 0 ~ -5
SubWoofer, Rear L/R, Center : 5 ~ -5
[Distance]
After you connected speakers to your unit,
set the Distance between the speakers and
your listening point if the distance of Center
or Rear speakers is bigger than the distance
of Front speakers. This allows the sound
from each speaker to reach the listener
at the same time. Press
I i
to adjust the
Distance of the selected speaker. This
distance is equivalent to a dierence of the
distance between Center or Rear speaker
and Front speakers.
[Test]
Select [Speaker Test Start] by using the
U u
and press
ENTER. Press
ENTER again
to stop. Adjust the volume to match the
volume of test signals memorized in the
system.
Comments to this Manuals