LG WM2355CS User Manual download pdf (Page 12)

I N S TA L L AT I O N I N S T RU C T I O N S

CONNECTING THE WATER LINES

Insert a rubber seal into the threaded

ﬁttings on each hose.

1

Rubber Seal

Water Hose

(to tap)

Rubber Seal

Water Hose

(to water inlet

on washer)

3

Attach the hot water line to the hot water

tap. Attach the cold water line to the cold

water tap.

Tighten the ﬁttings securely. Open the water

taps fully to check for leaks.

Water Tap

NOTE: Do not cross-thread the hose ﬁttings.

Attach the hot water line to the red hot water

inlet on the back of the washer. Attach the

cold water line to the blue cold water inlet on

the back of the washer. Tighten the fittings

securely.

2

Water

Inlets

• IMPORTANT: Use new hoses when installing

the washer. Do NOT reuse old hoses.

• IMPORTANT: Use ONLY the inlet hoses

provided by LG with this laundry product.

Aftermarket hoses are not guaranteed to ﬁt or

function correctly. Other hoses may not tighten

correctly and could cause leaks. Subsequent

damage to product or property will not be

covered under the terms of LG's warranty.

• Water supply pressure must be between 14.5

PSI and 116 PSI (100~800 kPa). If the water

supply pressure is more than 116 PSI,

a pressure reducing valve must be installed.

• Periodically check the hose for cracks, leaks,

and wear, and replace the hose if necessary.

• Make sure that the water lines are not stretched,

pinched, crushed, or kinked.

• The washer should never be installed or stored

in a location subject to freezing temperatures.

Damage to the water lines and internal

mechanisms of the washer can result. If the

washer was exposed to freezing temperatures

prior to installation, allow it to stand at room

temperature for several hours before use.

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 71 72

Comments to this Manuals

No comments