LG WD-R8012 User Manual

Washing MachineOWNER’S MANUALWD-R8012Thank you for buying aLG Fully Automatic Washing machine.Please read your owner’s manual carefully, it providesin

10nstallationIInstallation of drain hose• The drain hose should not be placed higher than100 cm above the floor. Water in the washer doesnot drain or

11nstallationILevel adjustment1. Adjusting the washing machine level properly prevents excessivenoise and vibration.Install the appliance on a solid

12are before washingC1. Care LabelsLook for a care label on your clothes. This will tell you about the fabric content of your garment andhow it should

13dding detergentA• Main wash only ➔• Pre Wash + Main Wash ➔• Do not exceed the maximum fill line.Close the dispenser drawer slowly.Overfilling can ca

14• The detergent should be used according to theinstruction of the detergent manufacture.• If too much detergent is used, too many sudscan occur and

15unctionFRecommended courses according to the laundry typeProper Program Fabric Type Temp.(Option)CottonSyntheticDelicateWool/SilkHandWashQuick 30Fi

16ow to use washerH• Press the Power button to start.• Press the Start/Pause button.• Initial conditions- Wash : main wash- Rinse : 3 times- Spin : 12

17ow to use washerH(1) Dial : Program(2) Button : Start / Pause(3) Button : Intensive(4) Button : Rinse Hold(5) Button : Rinse+(6) Button : Pre Wash(7

18ow to use washerH2. No spinSpin• By pressing the Spin button, the spin speedcan be chosen and the LED of rpm is turnedon. • If no spin is selected,

19Water Temp.• By turning the Program Dial, the watertemperature can be selected.- Cold- 30˚C / 40˚C / 60˚C / 95˚C• Water temperature can be selecteda

2roduct FeaturesPontentsCWarnings...3Installation...

20ow to use washerH1.Drying Automatic guideDry• This washer-dryer’sautomatical process fromwashing to drying can beselected easily.• For most even dry

21Dry2.Drying time guide• By press the Dry button, the drying timecan be selected.• Drying course can last up to 150min.When selecting drying only, d

22Program• 8 programs are available according to thelaundry type.• Lamp will light up to indicate selectedprogram.• When Start/Pause button is pressed

23ow to use washerHStart/Pause• This Start/Pause button is used to startwash cycle or pause the wash cycle.• If temporary stop of wash cycle isneeded

24ow to use washerH• If the machine encounters a faultduring operation, the associated faultwill be displayed.“ ” : Water pressure sensing error

25aintenanceM The water inlet filter- " " error message will blink on the control panel when water does not enter thedetergent dra

2632321100 The drain pump filter❋ The drain filter collects threads and small objects left in the laundry.Check regularly that the filter is clean to

27aintenanceM Dispenser drawer❋ After a while detergents and fabric softeners leave a deposit in the drawer.• It should be cleaned from time to time w

28aintenanceM Cleaning your washer1. ExteriorProper care of your washer can extend its life.The outside of the machine can be cleaned with warm water

29roubleshooting guide❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at anearly stage and react a

3arningsWFor your safety, the information in this manual must be followed to minimizethe risk of fire or explosion, electric shock, or to prevent prop

30roubleshooting guideTWasher does not startWasher will not spinDoor does not openWash cycle timedelayedDry problem • Does not dryDo not overload.Chec

31roubleshooting guideTSymptom Possible Cause Solution• Water supply is not adequate in area• Water supply taps are not completelyopen.• Water inlet h

32erms of WarrantyTWhat Is Not Covered:• Service trips to your home to teach you how to use the product. • If the product is connected to any voltage

P/No.: MFL49491501

4nstallationITo minimize the risk of fire in a tumble dryer, the following should be observed:• Items that have been spotted or soaked with vegetable

5SpannerInlet hose(1EA) AccessoriespecificationsS Name : Front loading washing machine Power supply : 240V~, 50 Hz Size : 600mm(W) x 550mm(D) x 850

6nstallationI1. To prevent internal damage duringtransport, the special 4 bolts arelocked. Before operating the washer,remove the bolts along with the

7nstallationILaundryTubWasherapprox.2cmDrain HoseLevel floor :Allowable slope under entire washer is 1˚Power outlet :Must be within 1.5 meters of eith

8nstallationI▶Water supply pressure must be between 30kPa and 1000kPa (0.3~10kgf/cm2)▶Don’t strip or crossthread when connecting Inlet hose to the val

9nstallationINormal Tap without thread & screw type inlet hoseNormal Tap without thread & one touch type inlet hose1. Unscrew the fixing scr