LG WD-14370RD User Manual download pdf (Page 33)

32

roubleshooting guide

T

Symptom Possible Cause Solution

• Water supply is not adequate in area

• Water supply taps are not completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are clogged.

• Drain hose is kinked or clogged.

• The drain filter is clogged.

• Load is too small.

• Load is out of balance.

• The appliance has an unbalance detection

and correction system. If individual heavy

articles are loaded (ex. bath mat, both robe,

etc.), this system may stop spinning or even

interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to

balance the load and repeat the spin cycle.

• Is the door opened or not

completely closed?

• Water overfills due to the faulty water valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Over load in motor.

• Water leaks

• The washer experienced a power failure.

• Check water supply.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose(s).

Clean and straighten the drain hose.

Clean the drain filter.

For more detailed information,

please refer to “The drain pump filter” on page27

Add 1 or 2 similar items to help

balance the load.

Rearrange load to allow proper

spinning

Close the door completely.

❋ If “ ”is not released, call for service.

Unplug the power plug and call for service.

Close the water tap.

Unplug the power plug.

Call for service.

Call for service.

Restart the cycle.

Turn the water tap on.

I f is not released, unplug power plug

and call service.

1 2 ... 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments