LG WD-12320BDK User Manual download pdf (Page 29)

28

roubleshooting guide

Symptom Possible Cause Solution

• Water supply is not adequate in area

• Water supply taps are not completely

open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are

clogged.

• Drain hose is kinked or clogged.

• The drain filter is clogged.

• Load is too small.

• Load is out of balance.

• The appliance has an unbalance

detection and correction system. If

individual heavy articles are loaded

(ex. bath mat, both robe, etc.), this

system may stop spinning or even

interrupt the spin cycle altogether.

• If the laundry is still too wet at the end

of the cycle, add smaller articles of

laundry to balance the load and repeat

the spin cycle.

• Is the door opend

or not completely

closed?

• Water overfills due to the faulty water

valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Over load in motor.

• The washer experienced a power

failure.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose(s).

Clean and straighten the drain hose.

Clean the drain filter.

Add 1 or 2 similar items to help

balance the load.

Rearrange load to allow proper

spinning

Close the door completely.

❋ If “ ”is not released, call for service.

Unplug the power plug and call for

service.

Close the water tap.

Unplug the power plug.

Call for service.

Restart the cycle.

T

1 2 ... 24 25 26 27 28 29 30 31

Comments to this Manuals

No comments