LG F1480TD6 User Manual download pdf (Page 9)

nstallation

1. Unscrew the adapter ring plate and the 4

adapter retaining screws.

2. Push the adapter onto the end of the tap

so that the rubber seal forms a watertight

connection. Tighten the adapter ring plate

and the 4 screws.

3. Push the water supply hose vertically

upwards so that the rubber packing within

in the hose can adhere completely to the

tap and then tighten it by screwing it to

the right.

• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 - 10.0 kgf / cm

)

• Do not strip or crossthread when connecting Inlet hose to the valve.

• If the water supply pressure is more than 1000 kPa, a decompression device should be

installed.

• Periodically check the condition of the hose and replace the hose if necessary.

Type-A : Connecting Screw-type hose to tap with thread

• Screw the hose connector onto water

supply tap.

■ Connecting water supply hose

Step1 : Check rubber seal inlet hose

Step2 : Connect hose to water tap

• Two rubber seals are supplied with the

water inlet hoses.

They are used for preventing water leaks.

Make sure the connection to taps is

sufficiently tight.

Upper

connector

Rubber

packing

Plate

Water supply

hose

Fixing screw

Hose

connector

Rubber

seal

Type-B : Connecting Screw-type hose to tap without thread

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

LG F1480TD6 User Manual Page 9