LG LDK-20 User Manual Page 80

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 79
IP LDK-20 Installation Manual Troubleshooting
76
SECTION 7. TROUBLESHOOTING
PROBLEM CAUSE / SYMPTOM SOLUTION
Power short circuit in
some board(s)
System power failure
LD6 LED light on the MBUB
is OFF or blinking
Exchange the malfunctioning board for one in good working
condition.
Dust each board.
Check the PSU fuse.
Replace the PSU with the appropriate type.
Power short circuit in
some board(s)
Bad board connection
System does not
operate
System database broken
Check the connection of each board with MBUB.
Press the Reset button.
Check the PSU.
Check the short circuit on MBUB or other boards.
Press the Reset button when the DIP switch (for database
protection) is in the default position.
Bad extension circuit Exchange the malfunctioning board for one in good working
condition.
Bad connection between
the MBUB/DTIB and keyset
The connection between the system and the keyset must
be repaired.
Check the connection between the line of SLIB and DTIB
on the MDF, and fix any mismatching.
The limit of installation
distance
Check the distance between the MBUB/DTIB and keyset.
DKTU does not
operate
Bad keyset Plug the keyset into another extension port that has been
verified as working.
If the keyset does not work, replace the keyset.
Bad MBUB or SLIB board Exchange the board for one in good working condition.
SLT does not operate
Bad connection between
the MBUB/SLIB and SLT
Check that the board connection between the lines of SLT
and DKT on the MDF, and fix any mismatching.
ACNR Fail Check the PRCPTU4, and CPCU4 CO line operation
Bad connection Check the connection.
The position of switch Check the switch for term and So/To position ISDN board does not
operate
Network problem Check the Network.
Noise on External
Paging port
Induced noise on the wire
between the system and the
amplifier
Use a shielded cable as the connection wire between the
system and amplifier.
A short shielded cable is recommended.
Distorted External
MOH
Excessive input level from
external music source
Decrease the output level of the external music source by
using the volume control on the music source.
Page view 79
1 2 ... 75 76 77 78 79 80

Comments to this Manuals

No comments