LG 55LS75C-M User Manual download pdf (Page 77)

ENGLISH

PICTURE ID Settings

y Only applies to certain models.

PICTURE ID is used to change the settings of a

specific set (display) using a single IR receiver for

multi-vision. Communication is possible between

a monitor with an IR receiver and other monitors

using RS-232C cables. Each monitor is identified

by a Set ID. If you assign the PICTURE ID using

the remote control, only displays with matching

PICTURE ID and Set ID can be controlled

remotely.

Assign the Set ID to the installed monitors as

shown below.

AUDIO

(RGB/DVI)

REMOTE

CONTROL IN

RS-232C OUT

RS-232C IN

RS-232C OUT

RS-232C IN

RS-232C OUT

RS-232C IN

IR & Light Sensor

RS-232C cables

PICTURE ID

2 Press the red ON button on the remote control to

assign the PICTURE ID.

Assign the Set ID to the selection of your choice.

y A set with a different Set ID from the PICTURE

ID cannot be controlled by IR signals.

NOTE

y If PICTURE ID is set to 2, only the upper

right monitor, which has a Set ID of 2, can be

controlled by IR signals.

y If you press the green OFF button for PICTURE

ID, the PICTURE IDs for all monitors are turned

off. If you then press any button on the remote

control, all monitors can be controlled by IR

signals regardless of Set ID.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 134 135

No comments

LG 55LS75C-M User Manual Page 77