Website: http://us.lgservice.comMICROWAVE OVENINSTALLATION INSTRUCTIONSPLEASE READ AND SAVE THESE INSTALLATION INSTRUCTIONS.P/NO.: 3828W5U0529
– 10 –STEP 3: Prepare The Venting BlowerYour microwave oven is shipped with the blower assembled for room-vented. You need to adjust the blower if you
– 11 –STEP 3: Prepare The Venting BlowerWALL-VENTED INSTALLATION:1. Remove one blower unit mounting screw and one orseveral blower plate mounting scre
– 12 –STEP 3: Prepare The Venting BlowerROOF-VENTED INSTALLATION:1. Remove one blower unit mounting screw andone or several blower plate mounting scre
– 13 –STEP 4: Prepare The Wall & Upper CabinetTo avoid personal injury or property damage, do not attempt to install this microwaveoven if you can
– 14 –STEP 4: Prepare The Wall & Upper CabinetDrill The Holes In The Wall And Upper Cabinet.1. Drill holes on the circles. If there is a stud, dri
– 15 –STEP 5: Install The Mounting PlateCenter LineACBDraw Center LineDraw Lines on StudsFor Wall-Vented OnlyMinimum 66"From the FloorSupport Tab
– 16 –STEP 5: Install The Mounting PlateSlide exhaustadaptor intoguides on rear panel.Exhaust AdaptorDamper (hinge side up)Locking TabsGuidesMounting
– 17 –STEP 6: Attach The Oven To The Wall1. Carefully lift microwave oven and hang it on support tabs(See Figure 27) at the bottom of the mountingplat
– 18 –STEP 6: Attach The Oven To The WallDamperPower supply Cord Clamp5. Roof venting installation: See Figure 33. Install ductwork through the vent o
Printed in China
– 2 –Your Safety FirstBEFORE YOU START• Proper installation is the installer's responsibility!– Read the entire manual before you begin. The mode
– 3 –Your Safety First• THIS APPLIANCE MUST BE GROUNDED!– If there is an electrical short circuit, grounding reduces the risk of electrical shock by p
– 4 –Your Safety First• MAKE SURE YOU HAVE ENOUGH SPACE AND SUPPORT.– Mount the oven against a flat, vertical wall, so it is supported by the wall. Th
– 5 –Parts, Tools, MaterialsTHE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:NOTE: Depending on your ventilation requirements, you may not use all of th
– 6 –Parts, Tools, MaterialsClear Tape(for taping the templates to the wall)Phillips Screwdriver(for the screws)PencilFlat Blade Screwdriver(for the t
– 7 –STEP 1: Prepare The Electrical ConnectionImproper grounding could result in electric shock or other personal injury.1. Locate the grounded electr
– 8 –STEP 2: Prepare The Venting SystemTHIS OVEN MUST BE PROPERLY VENTED!WARNINGNOTE: The ductwork you need for outside ventilation is not included wi
– 9 –STEP 2: Prepare The Venting SystemStandard FittingsNOTE: If the existing duct is round, you must use a rectangular-to-round adapter, with a recta
Comments to this Manuals