LG LRE30955ST User Manual download pdf (Page 34)

- 34 -

English

Español

REMOVING & REPLACING THE

WARMING DRAWER

To Remove Warming Drawer:

1. Open the drawer to the fully opened position.

2. Remove the 2 screws (right and left sides). (refer to the

illustration as below)

3. Locate glide lever on each side of drawer, push down on

the left glide lever and pull up on the right glide lever.

4. Pull the Warming Drawer away from the range.

To Replace the Warming Drawer:

1. Replace shield on the right glide of the drawer body.

2. Pull the bearing glides to the front of the chassis glide.

3. Align the glide on each side of the drawer with the glide

slots on the range.

4. Push the drawer into the range until levers click

(approximately 2 inches). Pull the drawer open again to

seat bearing glides into position. If you do not hear the

levers click or the bearing glides do not feel seated,

remove the drawer and repeat steps 2-4.

This will minimize possible damage to the bearing glides.

OVEN VENT

The oven vent is located above the left rear surface unit.

This area could become hot during oven use.

It is normal for steam to come out of the vent.

The vent is important for proper air circulation. Never block

this vent.

MAINTENANCE

Push down with finger

Lever

Pull up with finger

Lever

Remove screw

WARNING

• Turn POWER OFF before removing the

Warming Drawer.

- Failure to do so can result in severe personal

injury,death or electrical shock.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 87 88

No comments

LG LRE30955ST User Manual Page 34