LG LDG4315BD Owner's Manual download pdf (Page 17)

INSTALLATION

ENGLISH

Connecting the Range to Gas

Shut off the range gas supply valve before removing

the old range and leave it off until the new hook-up

has been completed.

Because hard piping restricts movement of the range,

the use of a CSA International-certified flexible metal

appliance connector should be used unless local

codes require a hard-piped connection.

A manual valve shall be installed in an accessible

location in the gas piping external to the appliance

for the purpose of turning on or shutting off gas to the

appliance.

Never reuse an old connector when installing a new

range.

To protect against gas leaks, use a qualified pipe joint

sealant on all external threads.

Install a male

" or

" flare union adapter to the

NPT internal thread of the manual shut-off valve,

taking care to back-up the shut-off valve to keep

it from turning.

Install a male

" flare union adapter to the

NPT internal thread at the inlet of the pressure

regulator. Use a backup wrench on the pressure

regulator fitting to prevent damage.

In an emergency situation or if you want to shut

off the gas supply, close the regulator valve by

positioning the lever as shown in the figure below.

Lever’s open

position

Lever’s closed

position

Connect a flexible metal appliance connector to

the adapter on the range. Position the range to

permit connection at the shut-off valve.

When all connections have been made, be sure

all range controls are in the Off position and turn

on the main gas supply valve. Gas leaks may

occur in your system and create a hazard. Gas

leaks may not be detected by smell alone.

Check all gas connection joints and fittings for

leaks with a non-corrosive leak detection fluid,

then wipe off.

Gas suppliers recommend you purchase and

install a UL approved gas detector. Install

and use in accordance with the installation

instructions.

WARNING

•

Do not use a flame to check for gas leaks.

•

Isolate the range from the gas supply system

by closing its individual shut-off valve during

any pressure testing of the gas supply system

at test pressures equal to or less than

" psig

(3.5 kPa).

Flexible Connector Hookup

Adapter

Pressure regulator

Flex connector

(6 ft. max.)

Adapter

Gas shut-off

valve

" or

" Gas

pipe

Gas Flow into Range

Installer: Inform the consumer of the location of the gas

shutoff valve

Pressure Regulator Position

Pressure Regulator

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Comments to this Manuals

No comments

LG LDG4315BD Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Cookers LG LDG4315BD