LG BH6830SW User Manual download pdf (Page 15)

Connecting 15

Connecting

About Ferrite Core (for EMI only)

This ferrite core can reduce noises.

How to attach the ferrite core

1. Pull the stopper [a] of the ferrite core to open.

2. Wind the rear speaker cables around the ferrite

core twice.

3. Close the ferrite core until it clicks.

If there is a strong electromagnetic wave

product nearby, interference may occur. Put

the unit (Wireless Receiver and main unit)

away from there.

If there is no audio signal for longer than

10 minutes, the Wireless Receiver will

automatically switch to standby mode. In

power saving mode, both LEDs will turn

red. LEDs will turn yellow when there is any

audio signal back.

If you operate main unit then wireless

speakers (rear speakers) sound within a few

seconds in standby mode.

Set the distance between this unit and

Wireless Receiver within 10 m (32 ft.).

Optimum performance can be

implemented only when the Wireless TX

and the Wireless Receiver within distance

of 2 m (6 ft.) to 10 m (32 ft.) is used since

communication failure may occur if longer

distance is used.

Be sure to match the speaker cable to the

appropriate terminal on the components:

+ to + and – to –. If the cables are reversed,

the sound will be distorted and will lack

bass.

It takes a few seconds (and may take longer)

for the Wireless TX and Wireless Receiver to

communicate with each other.

Use the rear speaker at least 30 cm (11 inch)

away from either TV screen or PC monitor.

Note

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 77 78

No comments

LG BH6830SW User Manual Page 15